Zavio D510E Guide d'installation télécharger pdf (Page 3)

Install the hardware and connect all cables

a. Wall mounting and Ceiling mounting

1. Unfasten the cover of the Dome IP Camera

2. Use the 2 supplied screws to fix the base of the

IP Camera to a flat surface. (vertical or horizontal)

3. Unscrew the pan screw; adjust the mini-case to

your desired pan angle and then screw tight the pan screw.

4. Unscrew the tilt screws; adjust the mini-case to

your desired tilt angle and then screw tight the tilt screw.

5. Fasten the cover.

b. Connect all cables

b1. Power over Ethernet (PoE)

1. Using a standard RJ-45 network cable, connect the IP Camera

to a PoE-enabled Hub / Switch / Router

b2. Without Power over Ethernet (PoE) connection

1. Connect the power adaptor to the IP Camera.

2. Using a standard RJ-45 network cable, connect the IP Camera

to a normal Hub / Switch / Router.

1 2 3 4 5 6 7 8 9 10

Pas de commentaire

Zavio D510E Guide d'installation Page 3